There are no products listed under this category.
Mod-Wall
Mod-Wall simplifies the specification, ordering, and onsite assembly process for the buildout of laboratories and commercial spaces. This innovative stainless steel modular wall system is manufacatured from type 304 stainless steel with a number 4 finish on all exposed surfaces. With Mod-Wall, you can customize your lab design with multiple sizes, layouts, service door configurations, windows, vents, equipment cutouts and other modificiations. The versatility and flexibility of the Mod-Wall modular wall system from Inter Dyne Systems provides the perfect solution for complete laboratory builds.
Mod-Wall modular wall system panels are made from 18 gauge (0.048") or thicker type 304 stainless steel, no wider than 46" which makes them easy to handle and install. Mod-Wall stud supports, pre-cut installation holes and stainless steel hardware further improve the quality and ease of install.
Mod-Wall Specifications
Modular wall fixed front panels and removable rear access panels are 18 gauge, 0.048″ or thicker and no wider than 46″ wide for ease of installation and handling.
Interior Mod-Wall stud supports are 16 gauge. 0.060″ or thicker, pre-located at sixteen-inch centers, and permanently installed with rivet-nuts on the rear side for attaching rear removable flat wall panels. Stainless steel hardware for making attachments is supplied.
Front panels feature 2″ forms on all sides for a non-visible means of attaching and rigidity.
Modular wall panels feature an 11 gauge, 0.120″ or thicker floor and ceiling plate inside of the wall sandwiched between the front panel and the stud support channels. Pre-punched 0.281″ holes allow for attaching to the floor and ceiling.
Modular wall system panel sections attach to each other with pre-placed 0.281″ installation holes through each 2″ stud support. Installation holes are also pre-located every 12″ on the front panel’s bent side.
Cut outs for equipment are supplied with loose angle trim to be applied in the field after equipment is in place, ensuring a snug finish.
Access doors are 1-½” thick with double pan interior stud design construction and 5-knuckle heavy-duty stainless-steel hinges, IDS# 1781A44 with non removable pins, and stainless-steel hardware. Access doors are supplied with locking lever, bolt-action door handle and furnished with two sets of keys.
Optional vision windows are acrylic or 0.250″ thick clear tempered glass and supplied with fixed stainless-steel trim on all four sides.
Optional door vents are double-sided 16 gauge 0.060″ or thicker stainless steel with four horizontal louvers.
2″ thick foam insulation is Owens Corning, FOAMULAR® 250 brand with an R-10 rating bonded into place.